Filter
Top Products
Supported Traps
OmniSwitch 6800/6850/9000—Release 6.1.3.R01 page 41
59 gmHwVlanRuleTableOverloadAlert all An overload trap occurs whenever a
new entry to the hardware VLAN rule
table gets dropped due to the overload
of the table.
60 lnkaggAggUp all Indicates the link aggregate is active.
This trap is sent when any one port of
the link aggregate group goes into the
attached state.
61 lnkaggAggDown all Indicates the link aggregate is not
active. This trap is sent when all ports
of the link aggregate group are no
longer in the attached state.
62 lnkaggPortJoin all This trap is sent when any given port
of the link aggregate group goes to the
attached state.
63 lnkaggPortLeave all This trap is sent when any given port
detaches from the link aggregate
group.
64 lnkaggPortRemove all This trap is sent when any given port
of the link aggregate group is
removed due to an invalid configura-
tion.
65 pktDrop all The pktDrop trap indicates that the
sending agent has dropped certain
packets (to blocked IP ports, from
spoofed addresses, etc.).
66 monitorFileWritten all A File Written Trap is sent when the
amount of data requested by the user
has been written by the port monitor-
ing instance.
67 alaVrrp3TrapProtoError all Indicates that a TTL, checksum, or
version error was encountered upon
receipt of a VRRP advertisement.
68 alaVrrp3TrapNewMaster all The SNMP agent has transferred from
the backup state to the master state.
69 gmHwMixModeSubnetRuleTableOverloadAlert — This trap is not supported in the cur-
rent release.
70 pethPwrSupplyConflict — This trap is not supported in the cur-
rent release.
No. Trap Name Platforms Description