Filter
Top Products
Features in 281-01 20
Version 281-02
C613-10482-00 REV B
CR00012868
ENCO 2 Entering the command create enco key=number ip=? caused the router or
switch to reboot.
This issue has been resolved.
YYYYYYYYYY
CR00012900
IPv6, Switch 2 When an IPv6 accelerator card was installed, IPv6 multicast traffic was flooded to
all ports in a downstream VLAN, whether or not they had joined the multicast
group.
This issue has been resolved.
-------YY-
CR00012911
Switch, VLAN,
User
2 Under very rare circumstances, memory corruption could occur when packets
were transmitted by the CPU out a switch port.
This issue has been resolved.
Y-Y-------
CR00012951
IPv6 2 RIPng (for IPv6) sometimes sent sub-optimal routes to its neighbours. When
RIPng was configured in a network with loop topology, this could cause unstable
routing table entries on the neighbours (the metric kept being updated, as a
result of updates from neighbours).
This issue has been resolved. RIPng no longer sends sub-optimal routes.
YYYYY- - YYY
CR00012952
Bridge 2 If a tagged packet was bridged out of a VLAN interface, the interface always
added a VLAN tag into the packet, even though the packet was already tagged.
This issue has been resolved.
YYY- ------
CR00012991
ATM 2 The maximum allowed value of the vpi parameter in the commands add and set
atm channel has been increased from 8 to 15.
Y---------
CR Module Level Description
AR400
AR7x5
AR750S / AR770S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948 / x900-48
AT-9900
AT-9800