Filter
Top Products
Features in 281-02 7
Version 281-02
C613-10482-00 REV B
CR00011710
Core 3 When the router or switch sent a RADIUS accounting STOP packet, the packet’s
Acct-Session-Time was always zero, no matter how long the session had been
active for.
This issue has been resolved.
Y
-Y- --- - - -
CR00013060
IPv6 3 Previously, if IPv6 had a dynamic Neighbour Discovery cache entry for a particular
IPv6 address, it prevented users from adding a static entry for the same IPv6
address.
This issue has been resolved. Users can now overwrite dynamic Neighbour
Discovery cache entries with static entries.
Y
-Y- --- - - -
CR00013117
IPv6, PIM,
PIMv6
3 A router or switch running PIM6 occasionally rebooted in certain network
topologies when links were very busy. The circumstances that caused this crash
are very unusual, but the code has been made more robust to cope with them.
Y
-Y- --- - - -
CR00013162
ISAKMP 3 When heartbeats fail for an ISAKMP SA, the router or switch (correctly) removes
the ISAKMP SA and any IPsec SAs that were created by the ISAKMP SA. It then
sends delete messages to notify the peer, so that the peer can also remove the
relevant IPsec SAs.
However, if heartbeats failed just after a re-negotiation, and only failed for the
new ISAKMP SA, then the router or switch did not send delete messages for any
IPsec SAs that were also removed. This could mean that encrypted traffic sent
from the peer was lost.
This issue has been resolved. If heartbeats fail, the router or switch now correctly
sends the peer device a delete message for any removed IPsec SAs.
Y
-Y- --- - - -
CR00013220
ISAKMP 3 Previously, if an ISAKMP policy was configured with set isakmp policy=name
prenegotiate=true and the peer was unresponsive, then at start-up the router
or switch sent fewer ISAKMP message retransmissions than the configured
msgretrylimit value.
This issue has been resolved.
Y
-Y- --- - - -
CR Module Level Description
AR400
AR7x5
AR750S / AR770S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948 / x900-48
AT-9900
AT-9800