Filter
Top Products
Chapter 21: Security
274
You need to specify the user name and password combinations when
configuring the RADIUS server software on the authentication server.
Note
This manual does not explain how to configure RADIUS server
software. Refer to the documentation that comes with the RADIUS
server software for instructions.
You must activate the RADIUS client software on the switch using the
AT-S110 Management Software and configure the settings. This is
explained in “Port Access Control Configuration” on page 269 and
“Radius Client Configuration”.
For more information about the RADIUS authentication protocol, refer
to the RFC 2865 standard.
Radius Client
Configuration
To configure the RADIUS client, perform the following procedure:
1. From the main menu on the left side of the page, select the Security
folder.
The Security folder expands.
2. From the Security folder, select RADIUS.
The RADIUS Page is displayed. See Figure 109.
Figure 109. RADIUS Page
3. To enter the RADIUS server’s IP address, enter the address in the
Server IP Address field in the format xxx.xxx.xxx.xxx.
4. Type the port number in the Server Port field that you want to assign
to UDP.
You may only assign one port number to this parameter.
5. Type the port number in the Accounting Port field that you want to
assign to UDP.
You may only assign one port number to this parameter.
6. To specify the server’s encryption key, enter the encryption key in the
Shared Secret field.
7. Click Apply to save your changes.