Filter
Top Products
AT-2973SX, AT-2973T, AT-2973T/4, and AT-VNC10S Adapters Installation and User’s Guide
97
Removing the Device Drivers
This section discusses how to remove the device drivers.
Note
Windows Server 2003, Windows Server 2008, and Windows Server
2008 R2 provide the Device Driver Rollback feature to replace a
device driver with one that was previously installed. However, the
complex software architecture of the NetXtreme II device may
present problems if the rollback feature is used on one of the
individual components. Therefore, Allied Telesis recommends that
changes to driver versions be made only through the use of a driver
installer.
To remove the device drivers, do the following:
1. In Control Panel, double-click Add or Remove Programs.
2. Click Broadcom NetXtreme II GigE Driver Installer, and then click
Remove. Follow the on screen prompts.
3. Click Yes to restart your system.
- or -
4. Click No to restart your system at a later time.
5. Click OK to acknowledge that the installation has been suspended.
The uninstallation of the driver is postponed until the next restart of
your system.