Filter
Top Products
Operating the Switch 19
Rapier Switch Software Release 2.2.1
C613-02013-00 Rev A
Figure 4: Example of output from the SHOW SYSTEM command
Configuration Scripts
At boot the switch executes the commands in the boot script to configure the
switch. A boot script is a sequence of standard commands that the switch
executes at start-up. The default boot script is called
boot.cfg
, but an
alternative script file can be defined as the boot script using the command:
SET CONFIG=filename
A configuration file is a script made up of the same commands as are used in
the CLI. It can be edited manually using the switch’s built in editor (“Editor” on
page 20), or uploaded to a PC and edited using any text editor using the
UPLOAD command (Chapter 1, Operation in the Rapier Switch Software Reference.
Saving Configuration Entered with the GUI
Configuration changes applied using the GUI automatically update the
configuration script specified in the SET CONFIG command.
Switch System Status Time 14:29:17 Date 12-Sep-2000.
Board ID Bay Board Name Rev Serial number
--------------------------------------------------------------------------
Base 86 AT-RP24 Rapier 24 P2-1 49867449
--------------------------------------------------------------------------
Memory - DRAM : 32768 kB FLASH : 6144 kB
--------------------------------------------------------------------------
SysDescription
CentreCOM AT-RP24 Rapier 24 version 2.1.0-00 04-Sep-2000
SysContact
SysLocation
SysName
SysUpTime
30262 ( 00:05:02 )
Software Version: 2.1.0-00 04-Sep-2000
Release Version : 2.1.0-00 04-Sep-2000
Release built : Sep 12 2000 at 14:28:59
Patch Installed : NONE
Territory : usa
Help File : help.hlp
Main PSU : On Main Fan : On
RPS Monitor : On RPS Connected : Yes
RPS PSU : On
Boot configuration file: vts.cfg (exists)
Current configuration: vts.cfg
Security Mode : Disabled
Warning (248283): No patches found.