Filter
Top Products
Patch 86261-04 For Rapier and AT-8800 Series Switches SHOW IGMPSNOOPING ROUTERADDRESS 13
Patch 86261-04 for Software Release 2.6.1
C613-10386-00 REV D
The AUTHENTICATION parameter has been removed from the “?” CLI
help for firewall commands. This was not a valid parameter.
Port speed and duplex values set with the SET SWITCH PORT SPEED
command were sometimes not applied correctly. This issue has been
resolved.
Occasionally some firewall timers stopped early, resulting in sessions being
removed prematurely. Because of this, TCP Reset packets could be sent by
the firewall before TCP sessions were finished. This issue has been resolved.
When executing the SET DHCP POLICY, DELETE DHCP POLICY and
DESTROY DHCP POLICY commands, memory was not de-allocated
correctly. This issue has been resolved.
Sometimes the device rebooted when a severe multicast storm occurred due
to a loop in the network. This issue has been resolved.
The prune time limit was not being cancelled when an IGMP join was
received by the switch. This was forcing the switch to send a Graft message
in the upstream direction. This issue has been resolved by cancelling the
prune time limit whenever an IGMP Join is received.
If ports were set to a speed of 100m when creating a switch trunk, the speed
could not subsequently be set to 1000m, even if the ports were capable of
that speed. This issue has been resolved.
The PORT and PORTPRIORITY parameters of the STP PORT command
were not always updating switch instances on ports that are members of
multiple STP instances. This issue has been resolved.
The RootDispersion value in NTP packets was negative. RFC 1305 states that
only positive values greater than zero are valid. This issue has been
resolved.
The checksum for the PIMv2 Register message for IPv6 was not being
calculated correctly. This issue has been resolved.
When the switch received a generation ID change message, it was not
responding by sending a PIM HELLO message. This issue has been
resolved.
PCR: 03993 Module: FIREWALL Level: 4
PCR: 03994 Module: SWI Level: 2
PCR: 03996 Module: FIREWALL Level: 2
PCR: 31001 Module: DHCP Level: 2
PCR: 31002 Module: UTILITY Level: 2
PCR: 31012 Module: PIM Level: 2
PCR: 31013 Module: SWI Level: 2
PCR: 31015 Module: STP Level: 2
PCR: 31017 Module: NTP Level: 3
PCR: 31019 Module: PIM6 Level: 2
PCR: 031020 Module: PIM Level: 2