Allied Telesis Patch 86261-04 Switch User Manual


 
16 SHOW IGMPSNOOPING ROUTERADDRESS Patch Release Note
Patch 86261-04 for Software Release 2.6.1
C613-10386-00 REV D
When the interval between the NTP server and client exceeded 34 years 9
days and 10 hours, the time set on the client was incorrect. This issue has
been resolved.
MVR was not operating if IGMP had not been enabled. This issue has been
resolved.
A fatal error occurred when the PURGE STP command was executed when
STP instances were defined with VLAN members. This issue has been
resolved.
The warning given when a QoS policy is active on a port operating at
reduced speed has been changed to reflect the problem more accurately. The
old message was:
Warning (2087343): Port <Port num> is currently used in QoS
policy <QoS policy num>, this policy may become incorrect
due to the port bandwidth.
The new message is:
Warning (2087350): Port <Port num> is operating at less than
its maximum speed: this may affect QoS policy <QoS policy
num>.
The PPP idle timer was not being updated correctly. This issue has been
resolved.
Ports sometimes stopped operating if the port speed was changed while
packets still occupied the switching fabric. This issue has been resolved. All
packets are now released before changes can be made to port
configurations.
When a ping was sent to the device’s link-local address, the device flooded
the ICMP Reply packet over the VLAN. This issue has been resolved.
The root bridge did not transmit BPDU messages with changed hellotime,
forwarddelay and maxage values. This issue has been resolved.
LDAP could not receive large messages spanning multiple packets. This
issue has been resolved.
PCR: 31058 Module: NTP Level: 3
PCR: 31063 Module: IPG Level: 2
PCR: 31068 Module: STP Level: 2
PCR: 31071 Module: SWI Level: 4
PCR: 31074 Module: PPP Level: 2
PCR: 31079 Module: SW56 Level: 2
PCR: 31080 Module: IPv6 Level: 2
PCR: 31082 Module: STP Level: 2
PCR: 31085 Module: LDAP Level: 3