Filter
Top Products
20 SHOW IGMPSNOOPING ROUTERADDRESS Patch Release Note
Patch 86261-04 for Software Release 2.6.1
C613-10386-00 REV D
AT-8800 series switches received frames when the physical link was not
established. This issue has been resolved.
When the device was configured as a DHCP server, a fatal error sometimes
occurred when a telnet session to the device was closed while DHCP was
reclaiming IP addresses. Also, a telnet error message displayed an incorrect
value when a telnet command line parameter was repeated (for example,
SHOW TELNET TELNET). These issues have been resolved.
If the DHCP server had a policy name greater than 5 characters long, and a
very long MERITDUMP or ROOTPATH value, the device could not
correctly create the configuration. This issue has been resolved.
A fatal error occurred when a long string of text was pasted over an existing
long string of text at the CLI. This issue has been resolved.
An ETH interface was sometimes shown as Up in the output of the SHOW
INTERFACE command when it was actually Down. This issue has been
resolved.
Under some circumstances traffic did not have NAT applied if a standard
subnet NAT rule was added to a public interface. Such rules did not
correctly match incoming traffic when the REMOTEIP parameter in the
ADD FIREWALL POLICY RULE command was not specified, and the
destination IP address was not the interface’s actual IP address. If this
situation occurred, traffic was redirected back out the public interface. This
issue has been resolved.
Filtering was not working correctly on AT-8848 switches between port
groups 1-24, 25-48, and the two GBIC ports. This issue has been resolved.
Port mirroring was not working correctly on AT-8848 switches where the
source, destination and mirror ports were spread between two or more of
the port groups 1-24, 25-48, and the two GBIC ports. This issue has been
resolved.
Software emulation of layer 3 hardware filtering was not operating
correctly. Packets that the switch had no routing information for were
filtered incorrectly. The first packet of a flow that should have been dropped
was not dropped, and a flow that should have been allowed was being
dropped. This issue has been resolved.
PCR: 03886 Module: SW56 Level: 3
PCR: 03888 Module: DHCP, TELNET Level: 2
PCR: 03895 Module: DHCP Level: 2
PCR: 03896 Module: TTY Level: 3
PCR: 03898 Module: ETH Level: 3
PCR: 03902 Module: FIREWALL Level: 3
PCR: 03903 Module: SWI Level: 2
PCR: 03904 Module: SWI Level: 3
PCR: 03906 Module: SWITCH Level: 2