Filter
Top Products
Patch 86261-04 For Rapier and AT-8800 Series Switches SHOW IGMPSNOOPING ROUTERADDRESS 23
Patch 86261-04 for Software Release 2.6.1
C613-10386-00 REV D
MAC address are now deleted from the all the internal tables for ports
where the learn limit has been exceeded.
On AT-8800 series switches, strict QoS scheduling is now enforced for ports
where egress rate limiting is applied. On Rapier i series switches, the same
QoS setup is now applied to all of the appropriate ports when setting up
egress rate limiting.
When saving the IP filter configuration, non-default values for the source IP
address mask were not always saved correctly. This issue has been resolved.
On AT-8800 series switches, if a port was set to use 10 Mbps full duplex with
the SET SWITCH PORT SPEED=10MBFULL command, there was a delay
before the port was set. This delay has been minimised.
On AT-8800 series switches, the temperature at which a temperature alarm
is generated has been increased.
Uplink modules on Rapier series switches sometimes did not enable a link
correctly. This issue has been resolved.
Availability
Patches can be downloaded from the Software Updates area of the Allied
Telesyn web site at www.alliedtelesyn.co.nz/support/updates/patches.html
. A
licence or password is not required to use a patch.
PCR: 03952 Module: SWI Level: 3
PCR: 03953 Module: SW56 Level: 3
PCR: 03969 Module: IPG Level: 2
PCR: 03976 Module: SW56 Level: 3
PCR: 03979 Module: CORE Level: 3
PCR: 31037 Module: SW56 Level: 2