Filter
Top Products
14 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
BIST failures were occurring because the software was not full supporting
the SwitchBlade 8 port 1000BASE-LX line card 1 (AT-SB4462). This issue has
been resolved.
STP was not being handled correctly when hot swapping line cards. This
resulted in links other than the preferred link being selected.
Also, when a layer two data stream was forwarded from one line card (the
source card) to another (the destination card) via the preferred STP link, if
the destination card had been swapped out, and the backup link was via the
source card, then the data stream would not be forwarded correctly over the
backup link.
These issues have been resolved.
PCR: 031033 Module: Level: 2