Filter
Top Products
36 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
If, with one or more routes already configured, BGP was enabled and an
additional route added, BGP was not aggregating the new route. This issue
has been resolved.
MLD did not respond correctly when it was in exclude mode and it received
a request block. This issue has been resolved.
When using the SET SWITCH PORT command, setting port intrusion
caused static MAC addresses to be deleted. This issue has now been
resolved.
The SNMP MIB browser was returning nonaligned pairs following a
GetNext of the FDB table. This issue has been resolved.
VLAN and IPG packet debugging facility has now been restored.
The CREATE CONFIGUATION command adds the PPP TEMPLATE LQR
parameter when LQR is enabled. But the configuration script always
contained “LQR=ON” even when the LQR value was not the default. This
issue has been resolved.
The EGRESS parameter setting was not displayed by the SHOW CONFIG
DYNAMIC command. This issue has been resolved.
The IFHC counter used within the SNMP MIB was producing incorrect
counts. This issue has been resolved.
The handling of the upstream neighbour for a GraftACK message has been
corrected.
The PORT parameter of the ADD ALARM command would not accept a
range of ports. This issue has been resolved.
Entering the command, SET SWITCH TRUNK SPEED was returning the
inappropriate error message, “The INSTANCE specified does not exist.”
This issue has been resolved.
PCR: 03254 Module: BGP Level: 2
PCR: 03256 Module: MLD Level: 3
PCR: 03257 Module: SWI Level: 2
PCR: 03260 Module: SWI, SNMP Level: 4
PCR: 03261 Module: VLAN, IPG Level: 4
PCR: 03262 Module: PPP Level: 3
PCR: 03263 Module: SWI Level: 4
PCR: 03265 Module: SWI Level: 3
PCR: 03266 Module: PIM Level: 2
PCR: 03273 Module: ALARM Level: 4
PCR: 03274 Module: SWI Level: 4