Allied Telesis SB251-13 Switch User Manual


 
Patch SB251-13 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 25
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
The SNMP MIB browser was returning nonaligned pairs following a
GetNext of the FDB table. This issue has been resolved.
VLAN and IPG packet debugging facility has now been restored.
The CREATE CONFIGUATION command adds the PPP TEMPLATE LQR
parameter when LQR is enabled. But the configuration script always
contained “LQR=ON” even when the LQR value was not the default. This
issue has been resolved.
The EGRESS parameter setting was not displayed by the SHOW CONFIG
DYNAMIC command. This issue has been resolved.
The IFHC counter used within the SNMP MIB was producing incorrect
counts. This issue has been resolved.
The handling of the upstream neighbour for a GraftACK message has been
corrected.
The PORT parameter of the ADD ALARM command would not accept a
range of ports. This issue has been resolved.
Entering the command, SET SWITCH TRUNK SPEED was returning the
inappropriate error message, “The INSTANCE specified does not exist.”
This issue has been resolved.
On SwitchBlade and AT-9800 Series switches, adding a static ARP entry
resulted in the entry of the MAC address being added for the next hop port.
These addresses were being incorrectly added if the next hop port was
configured as a tagged port. This issue has been resolved.
The timing of LLQ packets has been modified to be consistent with MLD
Draft (Nov 2002).
BGP/IPG was causing fatal errors to occur following network topology
changes. This issue has been resolved.
RIP packets can now contain up to 25 routes per packet instead of 24.
PCR: 03260 Module: SWI, SNMP Level: 4
PCR: 03261 Module: VLAN, IPG Level: 4
PCR: 03262 Module: PPP Level: 3
PCR: 03263 Module: SWI Level: 4
PCR: 03265 Module: SWI Level: 3
PCR: 03266 Module: PIM Level: 2
PCR: 03273 Module: ALARM Level: 4
PCR: 03274 Module: SWI Level: 4
PCR: 03275 Module: SWI Level: 2
PCR: 03278 Module: IPV6 Level: 4
PCR: 03280 Module: IPG, BGP Level: 1
PCR: 03285 Module: IPG Level: 4