Filter
Top Products
8 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
Hardware filters using classifiers that specified IP addresses were not
accepted by the ADD SWITCH HWFILTER command when added in a
particular order. This issue has been resolved.
If either the MCLIMIT or BCLIMIT parameter in the SET VLAN MCLIMIT
BCLIMIT command was set to NONE, the other parameter was sometimes
incorrectly set to NONE as well. This issue has been resolved.
OSPF sometimes chose routes with an infinite metric over routes with a
finite metric when selecting the best local route. This issue has been
resolved.
When browsing the ifInNUcastPkt MIB counter, the value was not correctly
incremented because only broadcast packets were counted. This issue has
been resolved.
A fatal error sometimes occurred when an IPv6 ping packet length
exceeded 1453 bytes. This issue has been resolved.
A fatal error occurred when the PIM path was recovering. This issue has
been resolved.
MLD startup query packets were not being sent correctly due to IPv6 MLD
being unaware of the IPv6 interfaces it was running on. This issue has been
resolved.
When some DHCP entries were in Reclaim mode, and all interface links
related to the range of these entries went down, these DHCP entries were
stuck in Reclaim mode. This issue has been resolved.
An STP blocking port did not discard SNAP encapsulated packets with
TYPE=00BB (ESRP packets). This caused a loop in the network. This issue
has been resolved.
The GUI install file was not copied to the slave controller card after
executing the SET INSTALL=GUI command. This issue has been resolved.
PCR: 03834 Module: SWCX Level: 2
PCR: 03835 Module: VLAN Level: 3
PCR: 03836 Module: OSPF Level: 2
PCR: 03837 Module: VLAN Level: 3
PCR: 03839 Module: IPV6 Level: 2
PCR: 03841 Module: IPG Level: 2
PCR: 03842 Module: IPG Level: 3
PCR: 03843 Module: DHCP Level: 2
PCR: 03846 Module: SWCX Level: 2
PCR: 03849 Module: SYSR Level: 2
PCR: 03850 Module: FFS Level: 3