Filter
Top Products
MULTI-TASKER™
400-0131-004
11
11
Example:
Command = [I2O*C4]
Feedback = (MA0202020202020202C04)
MA = Matrix Settings
0202…02 = Output connections
C04 = Card ID
Output Connection Description:
Reading from left to right, the first two digits are
for output 1, the next two for output 2, and so
on. Each two digit pair represents the input
number to which each output is connected.
7. [STA0]
This command disables automatic feedback
from the card and front panel. The command
affects any card with auto-feedback capability,
not just the MT105-100/101. The default at
power on or reset is STA0, off.
Command Format [STA0]
8. [ON]
This command will enable one or more outputs
for a single card, or a group of cards.
SINGLE CARD OPERATION
Command Format: [ONmCnUi]
m = Output number (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an MT105-100 card in slot 5. All of the
outputs are off.
1) [ON1C5]: Turns on only Input 1.
2) [ON3C5]: Turns on only Input 3. Inputs 1
and 3 are now on.
GROUP OPERATION
This command enables output “m” for each card
in group “k” of unit “i”.
Command Format: [ONmGkUi]
m = Output number (m = # from 1-8)
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
[ON1G1]: Turns on Output 1 for each card in
Group 1. See the GROUP commands for a
detailed explanation.
PATH OPERATION
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in “P” are
not executed immediately. The path for outputs
on multiple cards, or the same card, may be
preloaded.
Command Format: [ONmCnUiP]
m = Output number (m = # from 1 to 8)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
P = Path
Example:
There are two MT105-100 cards in slots 6 and
9. Enable Output 1 of card 6 and Output 3 of
card 9 simultaneously. To do this, send the
following commands:
[ON1C6P] , [ON3C9P] and [SW]
If “F” is included, use the [ONmCnPF] command
or the [ONmCnFP] command.
FEEDBACK OPERATION
Command Format: [ON…..F]
After processing a command, an “OK” or
“[ERR001]” will be returned as feedback if “F” is
included at the end of a command string.
Example:
[ON1C2F]: if path is not set
[ON1C2PF]: if path is set