Filter
Top Products
MULTI-TASKER™
400-0131-004
17
17
Command Format: [WRCn
1
Cn
2
…GkUi]
Cn = Card ID (n = slot # from 1 to max slots)
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group cards 2, 4, and 6 as group 5 of Unit ID 1
by sending the command [WRC2C4C6G5U1].
After executing this command, cards 2, 4 and 6
will be grouped together as group 5 of Unit ID 1.
The system will return the following feedback:
[G5=C2C4C6]
Now, when a command is sent to G5, each
board in G5 will execute the same command.
27. [RMC]
This command may be used to remove one or
more group members from a group. Reset the
system after using this command for all changes
to take effect.
Command Format: [RMCn
1
Cn
2
…GkUi]
Cn = Card ID (n= # from 1 to max slots)
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 consists of the cards located in slots
numbered 2, 4, and 6. Remove just cards 4 and
6 from the group by sending the command
[RMC4C6G1]. The system will return the
following feedback:
[G5=C2]
28. [RMG]
This command may be used to delete an entire
group, or all groups.
REMOVE A GROUP
Remove all the members from the group,
effectively deleting the group.
Command Format: [RMGkUi]
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 consists of the cards located in slots
number 2, 4 and 6. Remove all cards from the
group by sending the command [RMG5]. The
system will return the following feedback:
[G5=0]
REMOVE ALL GROUPS
Remove all the members from every group,
effectively deleting all groups.
Command Format: [RMG*Ui]
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 consists of cards 2, 4 and 6. Group 2
consists of cards 1, 2, 3, 4 and 5. Delete all the
groups by sending the command [RMG*]. The
system will return the following feedback:
G1-G8:EMPTY
29. [RD]
This command reads and then displays the
members in each group.
Command Format: [RDGkUi]
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 2, 4 and 6 are part of
group 5. Read the member data for group 5, by
sending the command [RDG5]. The system will
return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 (group 5) and then the
cards that make up group 5. In this case,
group 5 includes C2, C4 and C6.