Filter
Top Products
Chapter 2. CLI Syntax Reference
52 3ware Serial ATA RAID Controller CLI Guide
/c
x
add selftest=
ddd:hh
This command adds a new background selftest task to be executed on the day
ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour hh
(range 0 .. 23). Notice that selftest runs to completion and as such no duration
is provided. A maximum of seven selftest tasks can be scheduled. This
command will fail if no (empty) task slot is available.
Example:
//localhost> /c1 add selftest=Sun:16
adds a selftest background task schedule to be executed on Sundays at 16
hours (4:00 PM).
Setting Up a Selftest Schedule
Setting up a selftest schedule requires several steps, and several different CLI
commands in addition to /cx add selftest.
To set up the selftest schedule you want to use, follow this
process:
1 Use the /cx show selftest command to display the current schedule for
selftest tasks. (For details, see page 49.)
2 If any of the scheduled tasks do not match your desired schedule, use
the /cx del selftest command to remove them. (For details, see page 53.)
3 Use the /cx add selftest command to create the selftest schedule slots you
want (described above.)
4 Use the /cx set selftest=enable command to enable the schedule (this
enables all selftest schedule slots). (For details, see page 54.)
Note: If you do not enable autoverify for units or start a verification manually, your
verify schedule will not run, even if it is enabled with the
/cx set verify=enable command.
Warning: If all time slots are removed, be sure to also disable the schedule.
Otherwise the applicable background task will never occur