Filter
Top Products
Unit Object Commands
www.3ware.com 65
Unit UnitType Status %RCmpl %V/I/M Port Stripe Size(GB)
------------------------------------------------------------------------
u1 RAID-0 OK - - - 64K 3576.06
u1-0 DISK OK - - p0 - 298.01
u1-1 DISK OK - - p1 - 298.01
u1-2 DISK OK - - p2 - 298.01
u1-3 DISK OK - - p3 - 298.01
u1-4 DISK OK - - p4 - 298.01
u1-5 DISK OK - - p5 - 298.01
u1-6 DISK OK - - p6 - 298.01
u1-7 DISK OK - - p7 - 298.01
u1-8 DISK OK - - p8 - 298.01
u1-9 DISK OK - - p9 - 298.01
u1-10 DISK OK - - p10 - 298.01
u1-11 DISK OK - - p11 - 298.01
u1/v0 Volume - - - - - 2047.00
u1/v1 Volume - - - - - 1529.06
/c
x
/u
x
remove
[noscan] [quiet]
This command allows you to remove (previously called “export”) a unit.
Removing a unit instructs the firmware to remove the specified unit from its
poll of managed units, but retains the DCB (Disk Configuration Block)
metadata. A removed unit can be moved to a different controller.
noscan is used to not inform the operating system of this change. The default
is to inform the operating system.
quiet is used for non-interactive mode. No confirmation is given and the
command is executed immediately. This is useful for scripting purposes.
Example of interactive mode:
//localhost> /c0/u0 remove
Removing /c0/u0 will take the unit offline.
Do you want to continue?
Y|N [N]:
Note: After the unit is removed through the CLI, the unit can be physically
removed. Hot swap carriers are required to do this while the system is online.
Otherwise you must power down the system to prevent system hangs and damage.