Filter
Top Products
American DJ® - www.americandj.com - Accu Roller 250™ Instruction Manual Page 5 American DJ® - www.americandj.com - Accu Roller 250™ Instruction Manual Page 6
• Micro-Stepping Motors for Smooth Color and Gobo Transitions
• DMX-512 Protocol Compatible (Uses Eight DMX Channels)
• Independent Gobo and Color Wheels
• 7 Rotating Gobos w/ Shake, 1 Dichroic and 1 Beveled gobo +
Spot - All Replaceable
• 9 Colors, Plus White - With Rainbow
• RDMX - Lets you set the DMX address from any DMX Controller
• 3 Operating Modes - Master/Slave; Stand Alone; Sound Active
• Internal Microphone
• ZB-MSD250 Discharge Lamp, 250w 2000 Hours
• Edit and Save Scenes into the Memory
• Manual Focus Lens
• Variable Strobe (1-12 fps)
• 180˚ Pan Movement
• 45˚
Barrel Scrolling
• Digital Display for Address and Function Setting
Accu Roller 250™ Features
Accu Roller 250™ RDMX
Regarding RDMX :
1. The units will be shipped preset in 16 channel increments
from the factory
2. While using RDMX, if all units are set to the same DMX
address, all units will change to the new DMX address you
selected.
EXAMPLE: You have four units, and all the units are set to the
DMX address of “1”, and you change one unit to DMX address
“17”, this will cause all the units to change to DMX address
“17”.
All four units must be on 4 different starting addresses to indi-
vidually set the DMX addresses for each unit.
For more on this feature see pages 24-25.
For Your Own Personal Safety, Please Read and Understand This
Manual Completely Before You Attempt To Install Or Operate
This Unit!
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit.
• Be sure that the local power outlet match that of the required volt-
age for your unit.
• Do not attempt to operate this unit if the power cord has been
frayed or broken.
• Do not attempt to remove or break off the ground prong from
the electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user
serviceable parts inside.
• Never operate this unit when it’s cover is removed.
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged.
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
• Always mount this unit in safe and stable matter.
• Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to cords at plugs, convenience recep-
tacles, and the point where they exit from the appliance.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 40 for cleaning details.
• Heat -This fixture should be situated away from heat sources such
as radiators, heat registers, stoves, or other appliances (including
amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. Objects have fallen, or liquid has been spilled into the appliance.
B. The appliance has been exposed to rain or water.
C. The appliance does not appear to operate normally or exhibits a
marked change in performance.
Accu Roller 250™ Safety Precautions