Filter
Top Products
Accu Roller 250™ Controls and Functions Accu Roller 250™ Controls and Functions
1. Barrel Mirror - This is a highly reflective surface mirror specifically
designed to optimize and enhance beam output. Never use glass
cleaner that contain ammonia to clean the surface of the mirror (such
as Windex).
2. Lens Assembly - This high quality lens is a fully focusing. Focus
the lens by manually turning the lens in a clockwise or counter-clock-
wise direction until the desired effect is achieved.
3. Digital Display - This display shows the menu and operating func-
tions that you can choose from.
4. Mode/Esc Button - This button is used to enter the main menu and
submenus. It is also used to exit menus.
5. Up Button - This button is used to scroll forward when navigating
through the system menu.
6. Fuse Holder - This housing stores a 8 amp (4 amp 220v) GMA pro-
tective fuse. Never defeat the fuse, the fuse is designed to protect the
electronics in the event of severe power fluctuations. Always be sure
to replace the fuse with an exact match as the one being replaced,
unless otherwise told to do so by an authorized American DJ® service
technician.
7. Power Cord Inlet - This unit is equipped with a removable I.E.C.
power cord. Be sure to only use the power cord included with the
unit, this cord is designed to match the electrical requirements of the
unit. Other cords may cause the unit to overheat or malfunction. Volt-
age may vary from venue to venue, when connecting this unit to a
power supply be sure to connect to a matching power outlet. Never
use this fixture if the ground prong has been removed or broken off.
The ground prong is designed to reduce the risk of fire or electrical
shock in the event the unit suffers from an internal short.
8. XLR DMX Input Jack - This jack is used to receive an incoming
DMX signal or Master/Slave signal.
9. XLR Output Jack - This jack is used to transmit the incoming
DMX signal to another DMX fixture, or transmit a Master/Slave signal
to the next Accu Roller 250™ in the chain. For best results in DMX or
Master/Slave mode terminate this jack if it is the last unit in the chain.
See “Terminator” on page 13.
American DJ® - www.americandj.com - Accu Roller 250™ Instruction Manual Page 9
American DJ® - www.americandj.com - Accu Roller 250™ Instruction Manual Page 10
MODE/ENTER DOWN UP EXIT
1
9
10
11
13
5
4
3
2
6
7
8
12