Filter
Top Products
26
PHASE 7
MENU PROGRAMMING PROCEDURE
EVERY INDENTED STEP REPRESENTS THE “START/ENTER” KEY BEING PRESSED TO SELECT
A MENU ITEM. EVERY MESSAGE WITH A NUMBER BEFORE IT INDICATES THAT IT IS A
MENU SELECTION CHOICE. EVERY MESSAGE WITHOUT A NUMBER BEFORE IT INDICATES
THAT IT IS THE LAST MENU LEVEL.
I.E. MENU FLOW
FROM (“1: SELECT SYSTEM PARAMETERS”)
PRESSING “START/ENTER” PUTS YOU AT (0: DRYER SETUP)
PRESSING “UP ARROW” PUTS YOU AT (1: COOL DOWN SETUP)
PRESSING “DOWN ARROW” PUTS YOU BACK AT (0: DRYER SETUP)
PROGRAMMING MODE:
ENTERING:
MUST BE IN THE “READY” STATE.
PRESS “STOP/CLEAR” AND “UP ARROW” KEY SIMULTANEOUSLY.
(THIS WILL GET YOU INTO THE PROGRAMMING MODE.)
EXITING:
PRESS THE “STOP/CLEAR” KEY REPEATEDLY UNTIL THE PHASE 7 NON-COIN
MICROPROCESSOR CONTROLLER (COMPUTER) IS BACK TO THE “READY” DISPLAY. THE
“STOP/CLEAR” KEY WILL BRING YOU BACK ONE MENU LEVEL AT A TIME. AT THE FIRST
MENU LEVEL, IT WILL EXIT THE PHASE 7 NON-COIN MICROPROCESSOR CONTROLLER
(COMPUTER) FROM THE PROGRAMMING MODE AND RETURN TO THE “READY” STATE.
NOTES:
THE “UP ARROW” AND THE “DOWN ARROW” KEYS ARE USED TO SCROLL UP AND DOWN
A MENU SELECTION.
THE NUMBER KEYS CAN ALSO BE USED TO BRING THE PHASE 7 NON-COIN
MICROPROCESSOR CONTROLLER (COMPUTER) DIRECTLY TO A KNOWN MENU ITEM.
PRESS THE NUMBER OF THE DESIRED CYCLE, FOLLOWED BY THE “START/ENTER” KEY,
TO ENTER THE MENU CHOICE ASSIGNED TO THE NUMBER SELECTED.