Filter
Top Products
4
2.0 Safety! ENGLISH
CAUTION!
n To reduce the risk of electric shock, disconnect the Uninterruptible
Power Source from the mains before installing computer interface signal cable (when
used). Reconnect the power cord only after all signalling interconnections have been
made.
n Connect the Uninterruptible Power Source to a two-pole, three-wire grounding
mains receptacle. The receptacle must be connected to appropriate branch protection
(fuse or circuit breaker). Connection to any other type of receptacle may result in a
shock hazard and may violate local electrical codes.
n This Uninterruptible Power Source has an internal energy source
(the battery) that cannot be de-energized by the user. The output may be energized
when the unit is not connected to a mains supply.
n To properly deenergize the Uninterruptible Power Source in an emergency, move
the rear panel I/O switch to the O (off) position and disconnect the power cord from
the mains.
n Avoid installing the Uninterruptible Power Source in locations where there is
water or excessive humidity.
n Do not allow water or any foreign object to get inside the Uninterruptible Power
Source. Do not put objects containing liquid on or near the unit.
n To reduce the risk of overheating the Uninterruptible Power Source, avoid
exposing the unit to the direct rays of the sun. Avoid installing the unit near heat
emitting appliances such as a room heater or stove.