Filter
Top Products
Chapter 1 Setting Up the EnCore 420
CoreModule 420 QuickStart Guide 9
18) Enter BIOS Setup Utility
• Press the <Del> key during POST, or S to enter BIOS Setup.
• Use BIOS Setup during the initial boot to set the desired options
(time and date, alter the boot drive for the floppy drive, CD-
ROM, or hard disk drive, etc.).
• Refer to the next step to alter the boot sequence, while in Setup.
19) Alter Boot Order, only if
needed.
• If you need to alter the boot sequence to select a bootable device,
perform the items listed in this step.
a) Select the BIOS and Hardware
Settings menu as shown in the
figure to the right and press
Enter.
The sub-steps listed here
show you how to change the
Boot Sequence while in the
BIOS Setup Utility.
Ampro Setup Util
> BIOS and Hardware Settings <
Reload Initial Settings
Load Factory Default Settings
Exit, Saving Changes
Exit, Discarding Changes
enterBIOS02a
b) Select the first drive in the Boot
Order as highlighted to the right.
This example assumes Drive A
is a 3 ½” floppy drive, Drive C is
an IDE HDD, and the 3
rd
drive is
an IDE CD-ROM.
NOTE The CD-ROM or
CompactFlash (CF) must
be listed in Drive
Assignment and the Boot
Order to be recognized by
the BIOS. CF can only
be listed as C or D drive
in the Boot Order.
Ampro Setup Utility for CoreMod
[Drive Assignment]
Drive A 1.44 MB, 3.5”
Drive B (none)
Drive C HDD on Pri Master
Drive D CDROM on Pri Slave
Drive E
CDROM
Boot 4th
Boot 5th
(none)
[Boot Order]
> Boot 1st Drive A: <
Boot 2nd Drive C:
Boot 3rd
(none)
(none)
Boot 6th (none)
[Drive and Boot Options]
bootseq03a
c) Move the CD-ROM up in the
Boot Order.
d) Exit and Save changes.
• Use the Arrow keys and PU/PD keys to move the CD-ROM
up in the Boot Order.
• If you want to keep the floppy drive and hard drive in the boot
order, you will need to make changes to the other Boot Order
devices.
For example, change Boot 3
rd
to Drive A, to keep it in the
boot sequence.
20) If using a CompactFlash
• If you did not receive a CompactFlash card from Ampro, go to
the next step, Step 21.
• If you received a CompactFlash card from Ampro with your
system, use the compact flash card to boot the system.
• If you have to change the boot order to do so, refer to Step 19.
• If you do not intend to install the OS or additional drivers onto
the hard disk drive, skip Step 21. See jumper setting next page.