Filter
Top Products
Overview
3
NI Series WebConsole & Programming Guide
Update the On-board Master and Controller Firmware
Before using your new NI unit, you must first update your NetLinx Studio to the most recent
release.
Upgrade the on-board Master firmware through an IP Address via the Ethernet connector
(Upgrading the On-board Master Firmware via an IP section on page 12) (IP
recommended).
Upgrade the Integrated Controller firmware through an IP Address via the Ethernet connector
(Upgrading the NI Controller Firmware Via IP section on page 14) (IP recommended).
Configure NetLinx Security on the NI Controller
Setup and finalize your NetLinx Security Protocols (WebConsole - Security Options section
on page 27).
Program your NI Controller (Programming section on page 77).