Filter
Top Products
Rack LCD Console KVM Switch User’s Manual2
Safety
Read and adhere to the following important safety considerations when working with the Integrated
Analog KVM (Keyboard, Video, Monitor Switch) Rack LCD (Liquid Crystal Diode Monitor).
Note: 1. Read all of the instructions. Follow all warnings and instructions.
2. All work must be performed by American Power Conversion (APC
®
) authorized
personnel only.
Electrical Hazard:
1. If you are not sure if your power source is compatible with the
device requirements, consult your electrician or power company.
2. The device is designed for use with IT power distribution systems
with up to 230V phase-to-phase voltage.
3. The device is equipped with a 3-wire grounding type plug. Have an
electrician update your outlet if the plug does not fit. Do not attempt
to defeat the grounding plug.
4. Do not overload the AC supply branch circuit that provides power to
the rack. The total rack load should not exceed 80 percent of the
branch circuit rating.
5. Do not exceed the total ampere rating of the extension cord if an
extension cord is used.
6. Protect the system from sudden changes in electrical power with
a surge suppressor or uninterruptible power supply (UPS).
Warning: 1. Route the power cord and cables so they cannot be stepped on or tripped over.
2. Avoid the risk of electrical shock or equipment damage. Never push anything
through slots in the cabinet.
3. Avoid injury and equipment damage as a result of rack failure. Read and
adhere to the installation and safety instructions that accompany your racks.
Caution: 1.Serious damage will result if the device is dropped or falls.
2. Do not block ventilation openings.
3. Do not place the device near or over radiators or heat registers.
4. Do not use the device near water. Do not spill any liquid on the device.
5. Do not use liquid or aerosol cleaners. Clean the device with a damp cloth.
6. Use only the hardware provided to install the KVM Rack LCD in the rack.