Filter
Top Products
- 9 -
Surge Protected COAX/RF Connectors
The H10 provides surge protection for your CATV system,
Cable Modem, DSS, or Antenna system. The surge protection
feature prevents surges traveling over Coaxial data lines from
damaging the system.
Connect the coaxial cable from the CATV or Cable Modem
provider to the connector marked “IN.”
Connect other cable from the connector marked “OUT” to the
device being protected (CATV box or Cable Modem).
System Ground Terminal
The H10 provides for the connection of grounding wires from
all of your equipment to a central terminal lug. This ground
connection eliminates ground loop problems; tie all component
grounds to this screw to break any possible ground loops that
can cause an audible ‘hum’.
Circuit Breaker
The H10 also provides a “press-to-reset” circuit breaker. When
this breaker is “tripped” due to an electrical surge or overload,
the device pops out and shuts down output power to the outlets.
To reset the circuit breaker, push it straight inward.
CAUTION: When resetting the Circuit Breaker, push the but-
ton in quickly, and release the button. Do not hold the button
inward. Failure to comply may result in equipment damage.
Input Power Connector
Connect one end of the supplied AC power cord to the H10
Input Power Connector, connect the other end to the AC utility
power source (15 Amp, 120 Vac, 50-60 Hz).
2
3
4
5