Filter
Top Products
2
Note: You’ll need to obtain the specific cable for
your network separately. If you are not sure which
transceiver you need, see your network administrator
or support person.
Your Apple Ethernet CS II card has one of three
types of network connectors: twisted pair, coaxial, or
AAUI connector. No matter which type of connector
your card has, the procedure for installing your card
in a Macintosh is the same. Perform the steps in the
following procedure. Note that the Ethernet card
illustrations may look slightly different from your
Apple Ethernet CS II card.
1. Follow the specific setup information that came with
your Macintosh to open the back panel or lid and
locate the communication slot II inside the computer.
The material that comes with your Macintosh
includes instructions to help you avoid damage to
your computer’s components when installing the
card. Be sure you’ve shut down and turned off the
power to your computer before starting the
installation.
2. Remove the cover from the opening for the
communication slot II on the computer’s back panel.
Check the manual that came with your computer
for specific instructions.
3. Remove the card from its antistatic bag.
Handle the card by its edges and avoid touching
the components and connector as much as
possible.
WARNING
To avoid damage to the card and to
your other computer equipment, be sure that
you’ve turned off power to the computer
before beginning installation procedures.
Installing Your Apple Ethernet CS II Card