Filter
Top Products
4
To connect your card to the network, follow the
instructions for your specific card. Check the
illustration below to determine your card type.
Refer to the following pages for instructions on how
to connect your card:
m Apple Ethernet CS II Twisted Pair Card: page 4
m Apple Ethernet CS II Coax Card: page 5
m Apple Ethernet CS II AAUI Card: page 7
Connecting an Apple Ethernet CS II
Twisted Pair Card
1. Plug the twisted-pair cable from your network into the
RJ-45 port on your card.
Just as with a telephone wire connector, you’ll
hear a “click” when you plug in the cable.
2. Turn on the computer’s power switch and start up the
computer.
You’ve made the hardware connections. Turn to
“Installing Your Ethernet Software” later in this
booklet for software installation instructions.
Card’s green LED lights
up when there’s a good
network connection.
Other end of cable
connects to network
controller (hub).
RJ-45 connector clicks when
you attach it to the port.
CS II Thin
Coax Card
CS II Twisted-
Pair Card
CS II AAUI
Card
Connecting Your Card to the Network