Filter
Top Products
Hooking up the Printer and Computer
30
OS-204/214/314
Note :
Power Jack
The power supply barrel connector must be inserted into the
power jack on the back of the printer before connecting the
communication cables.
This printer comes with both a nine-pin Electronics Industries
Association (EIA) RS-232 serial data interface (for OS-202, it is
six pin) and a standard Centronics parallel interface. In either
case, you must supply the required interface cable for your
application.
Note :
This printer complies with FCC "Rules and Regulations" ,
Part 15, for Class B Equipment, using fully shielded six-foot
data cables. Use of longer cables or unshielded cables may
increase radiated emissions above the Class B limits.
Serial (RS-232) Interface Requirements
The required cable must have a nine-pin "D" type (for OS-202, six
pin) male connector on one end, which is plugged into the mating
serial port located on the back of the printer. The other end of this
signal interface cable connects to a serial port at the host
computer.
For technical and pinout information, please refer to the
Reference Technical Information-Interface Specification on page
55 of this booklet.
RS232 Serial Port
Parallel Port
OS-202
29