Filter
Top Products
Troubleshooting
B. Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Normally, when the printer is in abnormal condition, the "POWER"
LED will keep blinking. The printing work and the communication
between the host and printer will stop.
Possible Problems Solutions Remarks
Ribbon out Supply the ribbon roll
Ribbon jam Recover the jam
Ribbon sensor error Replace the ribbon sensor
Not applicable to
direct thermal type.
To understand the problem, please check both
LEDs first:
A. Power and Ready LEDs blink at the same tempo
Note:
Power LED Ready LED
ON ON
OFF OFF
**For models OS-203/OS-204 such error will never
occur.
C. Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible
Problems
Solutions Remarks
Miss-detect the gap
. Check the label path
. Check the label sensor
If you are using
continuous label roll
and run under
Windows, you should
select the continuous
media.
Label stock out . Supply the label roll out
Label stock not
installed
. Install the label roll
Label jam . Recover the jam
Possible
Problems
Solutions Remarks
Serial IO error . Check the baud rate Not for Centronics
Memory full Add the extension RAM
Cutter failed, or
jam at cutter
. Check the cutter
. Recover the jam
It occurred, only when
cutter is installed, or the
setting of the cutter
Hardware error Call for service
47
48