Filter
Top Products
16. Hook the dispenser bar on the brackets of the chassis, positioning it
above the white roller. Ensure that the dispenser bar is paralleled
with the black platen roller and it's long thinner end is at the left.
19. Click the top cover back to the middle cover.
20. Insert the sensor connector into its receptacle on the main logic
board of the base housing.
17. Secure back the screw on the left bracket of the chassis. 21. Click the middle cover back to the base housing. First click in the
front part then the rear. 18. Guide the sensor cable connector through the hole on the upper left
corner of middle cover. 22. Secure the two screws at the bottom of the base housing.
68
67