Filter
Top Products
Appendix I - Installing Dispenser Kit
6. Route the peeler sensor cable through the guides along the left side of
the top cover.
7. Fix the sensor cable and sensor board with Loctite-444 instant
adhesive or equivalent.
1. Turn off the printer power and unplug the printer.
2. Unwrap the PC bag of dispenser kit to take out the screw, the shaft,
the plastic roller, the dispenser bar, the direction label and the peeler
sensor cable.
64
Top Cover
3. Take off the top cover of the printer.
4. The peeler sensor cable has a sensor board at one end and a connector
at the other end.
5. Mount the two little holes of the sensor board on the two spines at
left upper corner inside the top cover, keeping the cable at the left.
63