Filter
Top Products
Chapter 2: Hardware setup
2-40
To re-install a SCSI backplane:
1. Position the backplane into its slot
with the component side facing
the rear panel, and the power
connectors on top.
2. Align the backplane with the rail-
like dents on the slot to ensure
that it fits securely.
3. Slide the backplane into the slot
until it fits. If correctly installed,
the outer edge of the backplane
aligns with the corner of the drive
cage.
4. Connect the appropriate cables to
the backplane. Refer to section
“2.9.2 SCSI backplane
connections” for information on
backplane cabling.
Rail-like dents