Filter
Top Products
30 ASUS CUVL-VM User’s Manual
3. HARDWARE SETUP
Connectors
3. H/W SETUP
4) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: To use this feature, enable the Wake-On-LAN feature in BIOS
(see 4.5.1 Power Up Control) and make sure that system has an ATX power
supply with at least 720mA +5V standby power.
5) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that the Power Up On External Modem
Act parameter is enabled (see 4.5.1 Power Up Control) and that the system has
an ATX power supply with at least 720mA +5V standby power.
CUVL-VM
CUVL-VM Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power.
+5 Volt Standby
PME
Ground
WOL_CON
CUVL-VM
CUVL-VM Wake-On-Ring Connector
WOR
RI#
Ground
21