Filter
Top Products
2-40 Chapter 2: Hardware information
5
6
5. Press the clip and connect the assembled tube to the waterblock. When
done, release the clip to tighten the two together.
6. Repeat Step 1 to 5 for another tube. Make sure that both tubes are well
connected to prevent leak, and then ll the coolant into the reservoir. The
picture shows a watercooling system installed to the motherboard.
3
2
1
4
For watercooling system with 1/2” or 10mm ID tubes
1. Insert a tting (1/2” to 3/8” ID or 10mm to 3/8” ID) into the tube.
Your watercooling system may come with tube clips. Use the clips to fasten the
ttings and the tubes together.
2. Connect a supplied 3/8” ID tube to the tting.
3. Firmly press a tube clip and hitch it to the bottom end of the 3/8” ID tube.
4. Press another clip and hitch it to the top end of the 3/8” ID tube.