Filter
Top Products
ASUS P2B-D/P2B-DS User’s Manual 31
III. INSTALLATION
Connectors
III. INSTALLATION
12. Wake-On-LAN (3-pin WOL)
This connector connects to LAN cards with a Wake-On-LAN output, such as the
AUS PCI-L101 (see section VII. ASUS LAN Card). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that the Wake-On-LAN Power Up Con-
trol is set to Enabled (see “Power Management Setup” under IV. BIOS SOFT-
WARE) and that your system has an ATX power supply with at least 720mA
+5V standby power.
1
1
R
P2B-D/DS Wake on LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5-volt
standby power
PME
Ground
+5 Volt Standby
13. Chassis Intrusion Sensor Lead (CHASSIS) (optional/reserved)
This lead is for a chassis intrusion monitor or sensor. The sensor is triggered
when a high level signal is sent to the CHASSIS lead. This occurs when the side
panel is opened or drive bay doors are opened. This motherboard has a light
detection on board, which detects extreme levels of light entering the chassis
such as when the chassis is opened. This function is available only with the
optional hardware monitor installed.
P2B-D/DS Chassis Open Alarm Lead
+5VSB
Chassis Signal
Ground
1
1
R