Filter
Top Products
3-12 Chapter 3: Software support
3.3.2 JMicron
®
RAID Conguration
The JMicron
®
Serial ATA controller allows you to congure RAID 0 and RAID
1 sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two HDDs, preferably with the same model and capacity.
2. A write-enabled oppy disk
3. Microsoft
®
Windows
®
OS installation disk (Windows 2000/XP/2003)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the external Serial ATA hard disk drives (HDDs) on your system.
2. Set the
JMicron RAID Controller item in the BIOS to [RAID]. See
section “2.4.4 Onboard Devices Conguration” for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID conguration.
4. Create a JMB363 RAID driver disk for Windows
®
OS installation. See
section “3.4 Creating a RAID driver disk” for details.
5. Install the JMB363 driver after the Windows
®
OS had been installed.
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select SubMenu F10: Save and Exit
Select Menu
ItemSpecicHelp
Press [Enter] to set
OnboardDevicesConguration
JMicron RAID controller
[IDE]
SATA Controller [Enabled]
SATA Controller Mode [IDE]
Ex-SATA/PCI-E*1 Option [Ex-SATA]
HDA Controller [Auto]
Onboard LAN [Enabled]
Onboard LAN Boot ROM [Disabled]
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378/IRQ7]
Parallel Port Mode [Bi-Directional]
ECP Mode Use DMA [3]
Phoenix-Award BIOS CMOS Setup Utility
Advanced