Filter
Top Products
P/I-P6NP5 User's Manual
21
5. Floppy drive connector (34-pin block )
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two plugs
on the other end to the floppy drives. (Pin 5 is removed to prevent
inserting in the wrong orientation when using ribbon cables with
pin 5 plugged).
Floppy Drive Connector
Pin 1
6. Power connector (12-pin block)
This connector connects to a standard 5 Volt power supply. To connect
the leads from the power supply, ensure first that the power supply is
not plugged. Most power supplies provide two plugs (P8 and P9),
each containing six wires, two of which are black. Orient the
connectors so that the black wires are located in the middle.
Using a slight angle, align the plastic guide pins on the lead to their
receptacles on the connector. Once aligned, press the lead onto the
connector until the lead locks into place.
Power Plugs from
Power Supply
Power Connector
on Motherboard
PG
+5V
-12V
-5V
GND
+5V
+12V
P9
P8
RED
RED
RED
WHT
BLK
BLK
BLK
BLK
BLU
YLW
RED
ORG
III. INSTALLATION
(Connectors)
III. INSTALLATION