Filter
Top Products
2-172-17
2-172-17
2-17
ASUS T2-AE1ASUS T2-AE1
ASUS T2-AE1ASUS T2-AE1
ASUS T2-AE1
2.10 Installing a floppy disk drive
The Terminator 2 system comes with one 3.25-inch drive bay for a floppy
disk drive.
To install a floppy disk drive:
1. Remove the front panel cover.
For instructions on how to
remove the front panel cover,
refer to steps 1-5 of section
“2.8 Installing an optical
drive.”
2. Carefully insert the floppy disk
drive into the floppy drive bay
until the screw holes align with
the holes on the bay.
22
22
2
3. Secure the floppy disk drive with
two screws.
4. Connect the floppy disk drive
signal cable to the signal
connector at the back of the
drive.
5. Connect the other end of the
signal cable to the floppy disk
drive connector (labeled
FLOPPY) on the motherboard.
See page 4-10 for the
connector location.
6. Connect a power cable from the
power supply unit to the power
connector at the back of the
floppy disk drive. See page 2-21 for
details on the power supply unit plugs.
44
44
4
66
66
6
33
33
3
33
33
3