Filter
Top Products
2-182-18
2-182-18
2-18
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installation
Configure your hard disk drive as Master device before connecting the
IDE cable and power plug. Refer to the HDD documentation on how to
set the drive as a Master device.
2.11 Installing a hard disk drive (HDD)
The system supports one Ultra ATA/133 IDE or one Serial ATA hard disk
drive.
To install an IDE hard disk drive:
1. Locate the HDD tray lock screw
on the other side of the chassis.
2. Remove the lock screw with a
Philips screw driver. Keep the
screw for later use.
4. Place a hard disk drive on the
tray with its bottom on the
open side. Align the HDD and
HDD tray screw holes.
5. Secure the HDD with four
screws.
3. Slide the HDD tray outward until
the tray slots are released from
the chassis hooks.
11
11
1
22
22
2
Tray locksTray locks
Tray locksTray locks
Tray locks
Tray locksTray locks
Tray locksTray locks
Tray locks
Lock slotsLock slots
Lock slotsLock slots
Lock slots
33
33
3
44
44
4
55
55
5
55
55
5