Filter
Top Products
OSD Factory Default Settings
The factory default settings are as follows:
Setting Default
Display Duration Always On
Display Mode The Port Number plus the Port Name
Scan Duration 3 Seconds
OSD Security
In order to prevent unauthorized access to the systems, the OSD provides a
password security feature. If a password has been set, the OSD will request
that the user specify it before allowing entry. To set a password:
1. Press [F6] to bring up the setup configuration menu.
2. Move the highlight bar to Set Password, then press [Enter].
3. Key in the new password, then press [Enter].
The password may be up to 8 characters long, and can consist of any
combination of letters and numbers (A - Z,0-9).
4. Key in the new password again, in order to confirm that it is correct, then
press [Enter].
If the two entries match, the new password is accepted and the screen
displays the following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start again from the beginning.
Note: To modify or delete a previous password, access the Password
function as in Steps 1 and 2, then use the backspace or delete key
to erase the individual letters or numbers.
2005-12-21
24 CS-9134 / CS-9138 User Manual