Filter
Top Products
10
Configuration: Ethernet
2.1 Getting an IP address
Set up your iPBridge by first getting an IP address, then use ATTO ExpressNAV to map devices.
The iPBridge is set up by default to request an IP
address from a DHCP server. If you do not have a
DHCP server to assign IP addresses to devices,
get an IP address from your network
administrator.
Use the QuickNAV utility from the CD included
with your iPBridge to find your iPBridge on your
network.
1 Work from the computer attached to the
iPBridge on the same broadcast domain. Find
and download the QuickNAV utility,
QuickNAV-windows.exe, from the CD
included with your iPBridge.
2 Turn on the iPBridge.
Wait for the iPBridge Ready LED to light, up to
three minutes, before proceeding.
3 Run the QuickNAV application.
a. Click Next on the QuickNAV Wizard
page.
b. Select your iPBridge serial number
from the list of choices displayed.
c. Click Next.
• If you are using DHCP, note the IP
Address assigned by the server:
_________________________________
• If you are not using DHCP, configure the
iPBridge with the IP Address and
Subnet Mask given to you by your
network administrator.
_________________________________
_________________________________
d. Click Launch Browser.
Your browser points to the
ExpressNAV splash screen.
4 Enter the user name and password values.
Note
The default values are
username
: “root” and
password
: “Password”. The user name is
case insensitive and the password is case
sensitive.
The iPBridge Status page appears.
5 Go on to Mapping devices: NDMP
on page 13
or Mapping devices: iSCSI
on page 15
depending on your model of the iPBridge 2500.