Filter
Top Products
47
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.5 SCSI configuration commands
The SCSI ports are configured with default settings but may be customized to your specifications using
the CLI commands in this section.
SCSIInitID
Specifies the SCSI initiator ID to be used on the specified
SCSI port. All maps coinciding with the user-specified
SCSIInitID must be set to offline and becomes invalid
upon issuing this command. Choices are 0 to 15.
Default: 7
Set syntax: set SCSIInitID [sb [0-15] ]
Requires a SaveConfiguration command
Get syntax: get SCSIInitID
SCSIPortBusSpeed
Controls the transfer rate at which the iPBridge tries to
negotiate with its SCSI devices.
Default: Ultra3
Set syntax: set SCSIPortBusSpeed [sb [fast | ultra | ultra2
| ultra3]
Requires a SaveConfiguration command
Get syntax: get SCSIPortBusSpeed [PortNum]
SCSIPortList
Returns a list of available SCSI ports and their current
status. Valid status values are
O.K.
and
Failed.
Immediate command: SCSIPortList
SCSIPortReset
Resets the specified SCSI bus.
Immediate command: SCSIPortReset [sb]
SCSIPortResetOnStartup
Specifies whether the SCSI port should be reset on power-
up or not.
Default: enabled
Set syntax: set SCSIPortResetOnStartup [sb [enabled |
disabled] ]
Requires a SaveConfiguration command
Get syntax: get SCSIPortResetOnStartup [sb]
SCSIPortSelTimeout
Indicates the time, in milliseconds, that the bridge waits
for a response from a SCSI device on the selected port
after a selection request.
Information only command: get SCSIPortSelTimeout [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
Default: enabled
Set syntax: set SCSIPortSyncTransfer [[sb [enabled |
disabled] ]
Requires a SaveConfiguration command
Get syntax: get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures/reports the SCSI internal termination of the
SCSI port identified.
Default: enabled
Set syntax: set SCSIPortTermination [sb [ enabled |
disabled]]
Requires a SaveConfiguration command
Get syntax: get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated.
Default: enabled
Set syntax: set SCSIPortWideTransfer [sb [enabled |
disabled] ]
Requires a SaveConfiguration command
Get syntax: get SCSIPortWideTransfer [sb]
SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port. Also updates the current logical to
physical address mapping configuration by updating the
status of any online maps/routes to unavailable if a device
is not found or to online if a device is found at the
respective SCSI address.
Immediate command: SCSITargets [sb]