Filter
Top Products
46
CLI
SNMPTrapAddress
Sets/displays the IP trap addresses and levels.Consult
your network administrator for further assistance with
SNMP.
Index: value between 1 and 6
IP Address: standard IP address
Trap Level: severity required for an event to trigger a trap:
.
None: no traps will be sent to the address
.
ALL: all triggering events will be sent
..
Informational: a trap will be issued to the given address
..
Warning: warning and critical events will be sent
.
Critical: only critical events will trigger a trap
Set syntax: set SNMPTrapAddress [Index] [IPAddress]
[none | all | warning | critical ]
Get syntax: get SNMPTrapAddress
SNMPTraps
Enables/disables SNMP trap functions.Consult your
network administrator for further assistance with SNMP.
Default: disabled
Set syntax: set SNMPTraps [enabled | disabled]
Get syntax: get SNMPTraps
TailEventLog
Displays new events to the terminal. Press <ESC> to exit
tail mode.
Immediate: TailEventLog
Temperature
Returns the current internal temperature in degrees
Celsius.
Immediate command: get Temperature
TraceLog
When enabled, records various aspects of traffic the
iPBridge receives to the trace log.
Default: disabled
Set syntax: set TraceLog [enabled|disabled]
Get syntax: get TraceLog
TraceLogFilter
Filters the display of data for specific iPBridge
subsystems when in TraceLog mode. If enabled for a
particular port, that port is masked when the command
TraceLogFilter is issued.
Default: disabled
Set syntax: set TraceLogFilter [ndmp | scsi | all ] [dp | sb
| all ] [enabled | disabled]
Get syntax: get TraceLogFilter [ndmp | scsi | all ] [dp| sb |
all ]
Voltage
Displays the current level of voltages monitored by the
iPBridge 2500.
VCC: +5.0V
VDDA: +3.3V
VDDB: +2.5V
ALL: all monitored voltages
Get syntax: get Voltage [VCC|VDDA|VDDB|ALL]
WrapEventLog
When enabled, the iPBridge logs up to 2,048 event entries
before wrapping (overwriting the first entries). If
disabled, the iPBridge stops logging event entries when
the buffer is full.
Default: enabled
Set syntax: set WrapEventLog [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get WrapEventLog
WrapTraceLog
When enabled, the iPBridge logs up to 2,048 trace entries
before wrapping (overwriting the first entries). If
disabled, the iPBridge stops logging trace entries when
the buffer is full.
Default: enabled
Set syntax: set WrapTraceLog [enabled | disabled]
Requires a SaveConfiguration command
Get syntax: get WrapTraceLog