Filter
Top Products
Assemblina
&
Connecting
continued
Connecting the Power
Plug the power cord to the power receptacle. Plug
the other end of the cord into
a properly grounded,
three-pin AC power outlet.
Note: Use an outlet not shared with equipment that
generates electrical noise or consumes large
amounts of electricity, such as an air conditioner or
off ice copier.
Turning the Power “ON”
Press the Power switch to turn the unit on.
When you turn the power on, ‘SYSTEM INITIAL’
message appears briefly in the display window and
all indicators light briefly. After a moment, all
indicators are turned off, and the date, time are
displayed. (If the displayed time and date are
incorrect, don’t worry
-
you will change this
information in a moment.). This confirms your unit
works properly.
You may leave your unit on and standby mode 24
hours
a day, 365 days a year.
Notes: If nothing appears in the window, make
sure that:
l The power cord is properly connected and
plugged into the wall jack.
l The wall jack is ‘live’ and not switched off by a wall
switch or blown fuse.
Choosing Dial
Mode
Set the DIAL Mode switch on the left side of the unit
for the type of service you have (pulse or tone).
If you are not sure which type of service you
have, do this simple test.
1. Lift the handset and listen for a dial tone.
2. Press any number other than 0. If the dial tone
stops, you have a touch-tone service. Set the
DIAL MODE switch to “TONE”
3. If the dial tone continues, set the DIAL MODE
switch to “PULSE”.
9