Filter
Top Products
Controlling Transmission Quality
Preparing a Good Original
To prevent jamming and ensure good results on
receiving fax machine:
.
.
Remove all staples, clips and tape from
original documents.
the
the
If you must re-fax a document that was faxed to
you, we recommend that you make
a copy of it
on a regular office copier, and fax the copy for
better transmission quality.
To create good quality original documents, do the
following:
l Type them instead of writing.
l When writing, use a felt-tip pen and black ink.
l Use white paper.
Do not try to send documents that are:
l
Wet or damp
l Covered with wet ink or paste
l Too thin (such as onionskin, airmail paper or
pages from a magazine)
l Chemically processed (such as pressure-sensitive
paper or carboncoated paper)
l Coated (such as glossy paper)
l Too small or short (such as a label or card)
l Made of cloth or metal
Use an office copier to piece together several small
originals or make a standard size copy of an
original which is too small to load in your unit.
Page
&
Document
Size
Limitations
Your unit accepts original documents no smaller
than 6 inches wide by 8.5 inches long, and no
larger than 8.5 inches wide by 59 inches long.
Do not attempt to load 2 or more documents into
the unit when the documents are too thin or too
thick.
These documents might fail in automatic
feeding. Feed one sheet at a time. Refer to the
following chart for acceptable thickness.
2 or
more
sheets
Single sheet
Thickness of
Document
0.08~0.13mm
0.075-0.15mm
Jote:
Make a standard copy by using an office
:opier
to send the document of
unacceptable
hickness.
Setting the Resolution
four unit allows to send a fax at a higher resolution.
Jse FINE resolution to send very detailed
documents with intricate drawings or small type.
Transmission time will be increased if FINE, mode is
set but the results will look better at the receiving
end
Vote: A document must be loaded into the unit for
:his
function to be operated.
To send a fax in FINE resulution, press [FINE]
Defore
dialing, the FINE indicator lights to confirm
;hat
the FINE mode is activated.
To see how your document will look at the receiving
end, use
your unit to make a copy with whatever
settings you like (NORMAL or FINE mode).
Making Copies
Your fax unit doubles as a handy copy machine.
1. Load the document face down into the unit.
2. Adjust the resolution of document by using
[FINE], if
necessary.
3.
Press
[START/COPY].
Note: If you copy 2 or more pages, be sure the
bottom sheet enters first.
23