Filter
Top Products
Chapter 3: Operations 23
For more information, see Connecting to devices using SSH on page 16, Access rights and levels on
page 23 and User Set command on page 72.
To delete a user:
Issue a User Delete command.
USER DELETE <username>
If the specified user is currently logged in, a message is sent to the user indicating that access is no
longer permitted, and the user’s Telnet session is terminated. For more information, see User
Delete command on page 72.
To display user configuration information:
1. To display information about one user, issue a Show User command, specifying the username.
SHOW USER <username>
2. To display information about all users, issue a Show User command with the All parameter.
SHOW USER ALL
For more information, see Show User command on page 67.
Access rights and levels
Most CPS appliance commands require the user to have access rights to use the commands. The
access rights for each command are listed in Table 4.4 on page 38. Table 3.3 describes the access
rights a user may be given.
Table 3.3: Access Rights
Access Right Description
PCON
The Port Configuration access right allows the user to modify port settings. Grant PCON
access only to users who need to issue the Port Set command.
SCON
The Server Configuration access right allows the user to change the CPS configurations,
including setting the IP address and updating the program load in FLASH. Grant SCON
access only to users who need to administer the CPS appliance.
SMON
The Server Monitor access right allows the user to view CPS appliance status and monitor
serial port activity. Grant SMON access only to users who need to assist other users in
accessing attached serial devices.
USER
The USER access right allows the user to modify the user database. Grant USER access
only to users who need to add users, change user specifications or delete users. At least
one user must have USER access rights; otherwise, the user database cannot be changed.
BREAK
The BREAK access right allows the user to send a serial break sequence to the attached
serial device. On certain devices, this sequence has a special meaning. Grant BREAK
access only to users who need to use the Port Break command.