Filter
Top Products
Chapter 5: CPS Appliance Commands 55
Syntax
SERVER PPP DISABLE|ENABLE
LOCALIP=<local_ip>] [REMOTEIP=<rem_ip>] [MASK=<subnet>]
Examples
The following command enables the PPP server with a local IP address of 192.168.0.1, a remote IP
address of 192.168.0.2 and a subnet mask of 255.255.255.0.
> ser ppp ena loc=192.168.0.1 rem=192.168.0.2 mas=255.255.255.0
The following command enables the PPP server with previously configured IP and subnet mask
values. This form of the command would not be valid unless the IP and subnet mask values had
been previously configured.
> server ppp enable
Server RADIUS command
The Server RADIUS command defines or deletes RADIUS parameters for the CPS RADIUS
client. For more information, see RADIUS authentication on page 25.
When you enter this command, you are prompted to confirm or cancel the specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER RADIUS PRIMARY|SECONDARY
IP=<radius_ip> SECRET=<secret> USER-RIGHTS=<attr>
[AUTHPORT=<udp>] [TIMEOUT=<time-out>] [RETRIES=<retry>]
- or -
SERVER RADIUS PRIMARY|SECONDARY DELETE
Table 5.14: Server PPP Command Parameters
Parameter Description
DISABLE|ENABLE Disables or enables the PPP server.
LOCALIP=<local_ip>
IP address to be used to connect the CPS appliance over the PPP connection. Must
be on same subnet as REMOTEIP address.
REMOTEIP=<rem_ip>
IP address to assign to the PPP client end of the PPP connection. Must be on same
subnet as LOCALIP address.
MASK=<subnet> LAN subnet for the PPP dial-in client.