Filter
Top Products
Cyclades-PR2000
24Chapter 4 - Step-by-Step Instructions
STEP FIVE
A static route must be added to tell the router that all traffic not intended for the local LAN should be sent to the
Access Provider. Chapter 9 of the Installation Manual explains static routes and other routing methods
available in CyROS. Fill in the spaces in Figure 4.6 with the values for your application.
Menu
CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE
Parameter Example Your Application
Destination IP Address Type in the word "DEFAULT".
Gateway or Interface
Interface
, because the IP addresses
are not known at configuration time.
Interface Slot 1 (SWAN) in the example.
Is This a Backup Route? No
OSPF Advertises This
Static Route
No
FIGURE 4.6 STATIC ROUTE MENU PARAMETERS
STEP SIX
NAT must now be activated. There are two varieties of NAT: Normal and Expanded. This example uses the
Normal NAT Mode. The other mode is explained in the chapter on NAT in the Installation Manual.
Menu CONFIG =>SECURITY =>NAT =>GENERAL
Parameter Example Your Application
Nat Status Enabled
Nat Mode Normal
Disable Port Translation No
FIGURE 4.7 NAT GENERAL PARAMETERS