Filter
Top Products
Display controller software installation
55
13. When the driver setup is complete, click the Finish button.
The Barco Product Installation Wizard will now guide you through
the installation of MediCal QAWeb, MediCal Pro, or NioWatch,
BarcoMed SelfExam, and the Barco on-line documentation.
14. When the Setup complete message appears, select Reboot
System Now and click Finish.
Automated display configuration
Once the drivers, software and documentation have been installed and
your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section, Setting
the resolution of your C
ORONIS display on page 102 in the
Troubleshooting section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your Barco system CD-ROM, see
Installing the B
ARCOMED display controller drivers and software on
page 53 of this manual.
Uninstalling the drivers and software
To un-install the BARCO MEDICAL IMAGING DISPLAY SYSTEM drivers, software or
documentation, please use the Windows Add/Remove Programs utility.
This can be found in the Windows Control Panel.
Note: If you installed your BARCO MEDICAL IMAGING DISPLAY SYSTEM drivers with
DualView enabled, the wizard may warn you that DualView must be
disabled before the drivers can be un-installed. This is normal, please
follow the prompts from the wizard.